Setup and Cleaning

Caution

1. Do not switch on chiller until proper setup completed
   • Water in the tub filled to at least 50% 
   • Hoses are properly connected 
2. Do not tilt chiller as damage to compressor may occur
3. Do not cover heat dissipation fan/vents 
4. Ensure chiller remains on the floor on a flat surface 

Operation (video)

1. Connect chiller inlet to SISU tub outlet (bottom connector); connect chiller outlet to SISU tub inlet (top connector)
2. Fill tub to desired water height (at least half full)
3. Switch on power
4. Check and remove trapped air in the chiller system to improve water flow (video)
5. Set desired temperature 
   • Select SET on chiller
   • Select UP/DOWN to desired temperature 
   • Select SET on chiller to lock in selection

Sanitation

1. Filter replacement (every 6-8 weeks or as needed)
   • Remove metal cover for UV/Filter compartment
   • Unscrew filter cup
   • Replace the filter 
   • Screw filter cup back on

Drainage procedure, recommend water replacement every 2-4 weeks or more frequently dependent on usage (video):

1. Connect garden hose to quick connect fitting 
   • Screw male end of garden hose into female quick connector fitting
2. Inside tub, plug finger into bottom opening (temporary stop water flow)
3. Disconnect bottom chiller hose from SISU tub (where finger is)
4. Connect garden hose with quick connect fitting onto SISU tub to drain water
5. Remove finger (water should begin draining)
6. When water level is below drainage hole, possible to drain remaining water on opposite side by removing cap
7. Deep clean your tub with hot water/dish soap as needed
8. Reconnect chiller to tub and refill water (at least half of tub) before turning on chiller

To use SISU as a cooler (for drinks or other food storage purposes)

1. Drain/clean SISU tub
2. Disconnect chiller hoses 
3. Thread male cap/plug to female quick connect fitting 
4. Put quick connecting fitting onto SISU tub 
5. Complete step 3 and 4 for inlet and outlet holes on SISU tub